Product Manual

M3A Vital Signs Monitor User Manual TEMP Monitoring (Optional)
- 70 -
monitoring state lasts for 10 min, then the monitor enters waiting state. — — — displays in the
TEMP parameter area on interface. Put the sensor back into the sensor bracket.
7 If necessary, repeat the measurement according to the procedure above.
NOTE:
1 After one measurement, the user should put the sensor back to the sensor bracket and
then take it out for starting a new measurement.
2 The monitor’s state can change from the PREDICT mode into the MONITOR mode, but
it can not change from the MONITOR mode into the PREDICT mode.
11.1.3 TEMP Setup Menu
11.1.3.1 TEMP Setup
Click on the TEMP Setup in the Main Menu to display the following figure:
Figure11-2 TEMP Setup
 Monitor: when this item is selectable, select it to enter monitor mode.
 Position: you can set this item to Oral, Auxillary or Recta. The axillary sensor can be used
for measuring oral/axillary temperature, while the rectal sensor for measuring rectal
temperature.
 TEMP Unit: Set temperature unit to ℃ or ℉.
11.1.3.2 TEMP Alarm Setup
Click on ALARM SETUP in the SYSTEM MENU, and set the alarm higher limit or lower
limit in the following figure: