User's Manual

SE-1200 Pro&SE-1201 Pro Electrocardiograph User Manual Editing ECG
- 33 -
Chapter 6 Editing ECG
The system can be configured to analyze ECGs after recording automatically. To
manually activate ECG data analysis, tap an ECG in the ECG File tab. Then the ECG
Analysis screen is displayed. You can edit, measure, diagnose, and compare ECGs on
this screen. The analysis screen is varied according to the ECG type. The following figure
shows the analysis screen of standard ECG as an example.
NOTE: The instructions in this chapter assume that the patient has been adequately
prepared and the electrodes have been placed correctly for the selected ECG test.
6.1 ECG View
To switch lead configuration, tap the configuration, e.g., 6×2+1R, on the top right of the
screen.
Slide the ECG traces left or right to view the 10s waveform. The time below the ECG
traces indicates the onset and offset of the on-screen waveform.
To zoom in on the waveform, double tap on the waveform of a lead. The magnification
page opens. Double-tap the page, and continue to zoom in. The ECG waveform can be
magnified up to 5 times. Double-tap the page to return to a one-time size when reaching
its maximum. To exit magnification, tap on the X in the upper right corner.
If the ECG waveform is not satisfactory, tap Re-sample to acquire ECG again.
If a lead is in the wrong location, tap Inversion to correct it.
6.2 ECG Measurement