User's Manual

SE-1200 Pro&SE-1201 Pro Electrocardiograph User Manual Basic Operation Guidance
- 22 -
CAUTION
3. If the electrocardiograph is turned off because of the low battery capacity or
unexpected power failure, the settings or the current ECG report may not be saved.
4. The electrocardiograph cannot print an ECG report when the battery is weak.
5. The use of electrocardiograph accessories (such as barcode reader) will deplete
battery power at a faster rate. The battery will require more frequent charging if these
accessories are used with the electrocardiograph.
To turn off the Electrocardiograph:
• When operating on AC power
Hold down the key to display the hint shutting down… on the screen. Then
the device will be off a few seconds later. Remove the plug from the outlet.
• When operating on battery power
Hold down the key to display the hint shutting down… on the screen. Then
the device will be off a few seconds later.
NOTE:
1. When turning off the device, follow the above sequence strictly, or there may be
something wrong on the screen.
2. Do not hold down the key when the device displays the hint information shutting
down… on the screen.
3.5 Loading Recorder Paper
SE-1200 Pro&SE-1201 Pro use folded thermal recording paper. When the paper is not
installed or when the paper is used up, the system will prompt No Paper, reminding the
user to install or replace the recording paper. For more details, see chapter 9, Error
Messages.
1. Squeeze the latch. Pull the paper door to the left. If any paper remains in the tray,
remove it.
2. Remove the outer packaging, including the cardboard bottom, from a new paper
pack. Pull the top sheet back so that the paper’s grid side faces up.
3. Slide the paper into the tray. Lay the top sheet over the paper door. Push the
entrance to the right until it clicks.