User's Manual

Acclarix LX9 Series Diagnostic Ultrasound System User Manual Getting Started
- 19 -
17.
PW
Press to get the sample line. Use the trackball to adjust
the position of the sample line. Press it again or press
<Update> key to display the Doppler strip. Rotate this
knob to adjust the gain in PW Mode.
In 3D/4D mode, rotating it can rotate the image by the
X-axis of the activated window.
18.
CW
Press to get the sample line. Use the trackball to adjust
the position of the sample line. Press it again or press
<Update> key to display the Doppler strip.
This knob is only available when the current active
transducer is a phased transducer .
In 3D/4D mode, rotating it can rotate the image by the
Y-axis of the activated window.
19.
M
Press to enter or exit M Mode and rotate to adjust the
gain in M Mode. Use the trackball to adjust the M sample
line.
In 3D/4D mode, rotating it can rotate the image by the
Z-axis of the activated window.
20.
3D
Press to enter or exit 3D Mode. It is only available when
the current active transducer is a wobble transducer.
21.
4D
Press to enter or exit 4D Mode. It is only available when
the current active transducer is a wobble transducer.
22.
Quad
Enters quad split screen. Each single press on it toggles
between four image windows.
23.
Dual
Enters dual split screen. Each single press on it toggles
between two image windows.
24.
Single
Press to display the currently active side of Dual image
as a single image.
25.
Update
In measurement, pressing <Update> switches the active
side of calipers. See section 8.1 for details.
In Pre-Doppler mode, pressing <Update> invokes
Spectral Doppler mode. When Spectral Doppler strip is
displayed, pressing Update allows switching between
live acquisition of the Doppler strip or the reference
image.