User's Manual

- 123
-
Acclarix LX9 Series Diagnostic Ultrasound System User Manual
Measurements and Reports
8.1 Generic Measurements
Generic measurements is invoked by pressing <Caliper> key on the control panel. Each imaging
mode supports different types of generic measurements. This chapter describes all the generic
measurements supported in each imaging mode.
8.1.1. B-mode Generic Measurements
The generic measurements supported in B-mode are listed in the table below.
No.
Measurement
Group
Measurement Item
Remark
1.
Distance
Dist. 2 Point
Dist. 2 Line
Length Trace
Ratio D1/D2
2-point distance method
Stenosis% Dist.
2-point distance method
2.
Circ/Area
Area Ellipse
Area Trace
Area Spline
Ratio A1/A2
Ellipse method
Stenosis% Trace
Stenosis% Ellipse
Stenosis% Spline
3.
Angle
Angle 3 Point
Angle 2 Line
4.
Volume
Volume 3 Dist.
Ellipse 1 Dist.
5.
Vessel
Diam.2 point
2-point distance method
Diam. Ellipse
Ellipse method
Stenosis% Diam.
Stenosis% Area
IMT
2-point distance method
VF Area
2-point distance method
6.
Elastography
Eratio-Area
Only available for Elastography
mode.
Eratio-Trace
8.1.1.1. Distance
The distance measurement measures the distance between two points.
2- Point Method:
1. Invoke the generic measurement function.
2. Select Distance-> Dist. 2 Point.
3. Move the caliper to the start point.
4. Press the <Set> key to fix the start point.