User's Manual

Telemetry Transmitter User Manual Installation of telemetry monitoring system
Chapter 3 Installation of Telemetry Monitoring System
NOTE:
1. The entire system must be specified by the personnel authorized by EDAN.
2. To ensure that the system works properly, please read the user manual and follow the
steps before using.
3.1 Initial Inspection
Before unpacking, check the packaging and ensure that there are no signs of mishandling or
damage. If the shipping cartons are damaged, contact the carrier for compensation and package
them again.
Open the package carefully and remove telemetry transmitter, MFM-CMS and accessories.
Check that the contents are complete and that the correct options and accessories have been
delivered.
If you have any question, please contact your local supplier.
3.2 Installation Environment
System working environment should be in consistent with the requirements in this user manual
(refer to A.2.2 Environmental Specifications).
System working should avoid noise, shock environment and the environment where the
concentrations of flammable anesthetics or other explosive materials may occur. The surrounding
of device should have enough space (at least 5 cm) to maintain and transfer heat.
NOTE:
1. Please keep the system away from radio transmitters and high power electrical and
mechanical device for those could affect monitoring.
2. Wireless transmission is applicable to the system. It’s normal that irregular waveform
due to outside interference may occur. If you have any question on Electromagnetic
environment, please contact service personnel.
3.3 Power Supply Requirement
Power supply should be in consistent with the requirements in this user manual (refer to A.2.4
Battery).
NOTE:
1 Connect the power cable of MFM-CMS to the socket specialized for hospital use.
2 Only use the power cable supplied by EDAN.
- 24 -