User's Manual

Telemetry Transmitter User Manual Care and Cleaning
Chapter 21 Care and Cleaning
Use only the EDAN-approved substances and methods listed in this chapter to clean or disinfect
your equipment. Warranty does not cover damage caused by using unapproved substances or
methods.
EDAN Instruments has validated the cleaning and disinfection instructions included in this User
Manual. It is the responsibility of the healthcare professional to ensure that the instructions are
followed so as to ensure adequate cleaning and disinfection
21.1 General Points
Keep your device, cables and accessories free of dust and dirt. To prevent the device from
damage, please follow the procedure:
 Use only recommended cleaning substances and disinfectants listed in this manual.
Others may cause damage (not covered by warranty), reduce product lifetime or cause
safety hazards.
 Always dilute according to the manufacturer’s instructions.
 Unless otherwise specified, do not immerse any part of the equipment or any accessories
in liquid.
 Do not pour liquid onto the system.
 Do not allow liquid to enter the case.
 Never use abrasive material (such as steel wool or silver polish).
 Inspect the telemetry transmitter and reusable accessories after they are cleaned and
disinfected.
CAUTION
If you spill liquid on the equipment, battery, or accessories, or they are accidentally
immersed in liquid, contact your service personnel or EDAN service engineer.
21.2 Cleaning
If the device or accessory has been in contact with the patient, then cleaning and disinfection is
required after every use. If there has been no patient contact and there is no visible contamination
then daily cleaning and disinfection is appropriate.
The validated cleaning agents for cleaning the telemetry transmitter and reusable accessories are:
 Mild near neutral detergent
 Ethanol (75%)
 Isopropanol (70%)
Cleaning agents should be applied and removed using a clean, soft, non-abrasive cloth or paper
towel.
- 96 -