Use Instructions

iSE Series Electrocardiograph User Manual Recording an ECG
To carry out pre-sample recording:
1. Select System Setting > Sampling Setting > Sampling Mode > Pre-sample.
2. Tap . ECG recording screen opens. The system automatically checks if 10s ECG
has been acquired. If no, the system will continue to acquire ECG till reaching 10s. If
yes, the system records and analyzes the ECG.
NOTE:
Gain, filter, and speed are not allowed to change during ECG recording.
To change the lead configuration e.g. 6×2+1R, slide the ECG traces left or right.
5.3 Rhythm ECG
In this sampling mode, rhythm strips from 10s to 30 min can be recorded. You can select
the leads to display and record in the rhythm strips. To configure, see system setting >
sampling setting > rhythm leads. Stop recording whenever you want by tapping the stop
button. Rhythm strips allow storage, transmission, and printing.
5.4 Pharmaceutical Study
Up to 30 min ECGs can be recorded for pharmaceutical study. The acquired ECGs allow
storage, transmission, and printing. During the experiment, you can stop recording or
printing by tapping the stop button. To configure the recording time and ECG report, see
system setting > printing and storage setting > pharma study record info.
5.5 VCG and SAECG
The VCG converts the P/QRS/T into spatial loops in the transverse, right sagittal, and
frontal planes. Each plane displays coverage percentile of the P/QRS/T loop in the four
quadrants. The mark is used to indicate the orientation of loop movement by its
round head. Tap on the P/QRS/T gain to change. The gain of P loop and T loop will be
synchronized. VCG can be recorded up to 5 minutes. The VCG allow storage,
transmission, and printing.
5.6 HRV
HRV is measured based on 12-lead ECGs. Five minutes of ECGs are recorded by
default. You can select the leads to display in this test by tapping the lead name. Stop
recording when you want to. The acquired ECGs allow storage, transmission, and
printing.
- 38 -