User's Manual

Patient Monitor User Manual Alarm Information
- 50 -
Message Cause
Resetting NIBP module in resetting
Please Start NIBP module is in idle status.
Done NIBP measurement successfully done
Continual Measuring NIBP module performs continual measuring
Stat Measuring NIBP module performs STAT function.
Please Switch To Maintain Mode
NIBP module is in normal mode, the user can’t start leak
test and pressure calibration. Please enter User Maintain >
NIBP Maintain and switch to Maintain Mode to perform
leak test or pressure calibration.
Please Switch To Normal Mode
NIBP module is in maintaining mode, the user can’t start
blood pressure measurement. Please enter User Maintain
> NIBP Maintain and switch to Normal Mode to perform
blood pressure measurement.
Quick TEMP Is Warming Up Quick TEMP Is Warming Up.
Place Probe On Measure Place Probe isn’t placed on the measurement site.
CO
2
Standby
Turn from measuring mode to standby mode, making the
module in energy-saving status.
CO
2
Sensor Warm Up The CO
2
module is in warm-up state.
Zeroing... The CO
2
module is performing the zero calibration.
Excessive C.O. Temp TB measuring value is beyond measuring range.
Excessive Temp, C.O.
Measurement Fail.
C.O. measuring needs parameters.
C.O. measure need param HEMOD calculation needs parameters.
Insufficient factors for Hemod
Dynamics
HEMO Dynamics calculation needs parameters.
No Sensor, C.O. measurement
fail
No Sensor,C.O. measurement fail
Measuring... The C.O. module is performing measuring.
Ready for new measurement C.O. module is ready for new measurement.
Invalid C.O. result C.O. measurement result is invalid.
C.O. Measurement Complete C.O. Measurement is completed.
C.O. Measurement Abort C.O. Measurement is aborted.
Warm-up over The monitor displays this message after taking the sensor
out of the bracket and warm-up is over.