User's Manual

i15 Blood Gas and Chemistry Analysis System User Manual Troubleshooting
- 110 -
18
The prompt “Barcode Cannot be Identified”
appears.
Ensure that the bar code is that of a calibrant
fluid pack.
19
The prompt “Calibrant Pack Can’t be Used,
Please Scan Again” appears.
Ensure that the bar code is that of a new
calibrant fluid pack and that the new
calibrant fluid pack has not expired.
20
The calibrant fluid pack chamber door can
not be opened.
Ensure that the calibrant fluid pack chamber
lock has been unlocked before opening the
door.
21
T
he system fails to scan the calibrant fluid
pack or test cartridge bar code.
C
heck that the calibrant fluid pack or test
cartridge bar code is not destroyed, and scan
it again.
22 Paper does not run from the paper tray.
O
pen the printer casing, adjust the paper
position carefully, and close the printer
casing. Press Print to print a record.
23 Paper-jam appears.
If a jam occurs for the first time, it might be
caused by an inappropriate placement of the
paper. In this case, open the paper casing,
remove the paper from
the paper tray,
remove the paper
with rumples, put the
paper in the paper tray again, adjust the
position of the paper carefully and close the
casing. If the problem continues, please
contact EDAN or its authorized distributors
for assistance.
24 The prompt “Paper?” appears.
Check whether there is paper in the printer
tray. I
f it has been depleted, load paper
again, and shut the printer casing. I
f the
problem continues, please contact EDAN or
its authorized distributors for assistance.
25
T
here is no sound after you successfully
press the touch screen.
Check the volume setup.
26
T
he system can not be connected to a
network through WIFI.
E
nsure that the intensity of the network
signal is strong and that the network setup is
correct.
27
T
he system can not communicate with the
DMS.
Ensure that the network or WIFI is
successfully connected, and that the IP
address of the DMS is correct.