User's Manual

SE-1010 PC ECG User Manual Operation Instructions for Exercise ECG
- 92 -
7.2.1 Setting Target HR
The system applies the following formulas to calculate the target heart rate.
220 and 85 are default values, and you can modify them in different situations in the Exercise
ECG Setting window.
7.2.2 Setting Normal BP
Set the normal BP range in the Exercise ECG Setting window. When the patient’s BP exceeds
the normal BP range, the system will consider it as abnormal status.
7.2.3 Setting a Protocol
Select a protocol from the pull-down list .
7.2.4 Setting Post J
Select a Post J value from the Post J pull-down list in the Exercise ECG Setting window.
Post J is the length after J point of the ST segment. You can set Post J to 0ms, 20ms, 40ms, 60ms
or 80ms.
NOTE: J Point is the connection point between the end of QRS complex and the start of
ST segment. It is the standard point to fix the position of ST segment in this
system. Please select the proper option based on the patient’s actual ECG
waves.