User's Manual

SE-1010 PC ECG User Manual Configuring the System
- 131 -
Only if Enable System Integration is selected, can Device ID and Output Path be set.
Device ID and Output Path should be set to the same values as those of Smart ECG Net.
Otherwise, data of this system can not be uploaded to Smart ECG Net system normally.
If the System Integration is activated, the system will save two copies of data, one is saved to the
data path of the system, and the other is saved to the output path, the default of which is system
disk: \SENData\.
9.3.5.2 Setting Barcode
Click on the Barcode Setting tab to display the following window.
NOTE: You can make related settings only for two-dimensional bar code readers in the
Barcode Setting window.
Enter the start and end addresses, the male and female codes and the device port, and then click
on the OK button confirm.
If the bar code reader cannot be automatically detected, you can make related settings as the
following procedures show:
1. Connect the bar code reader to the PC
2. Click on start, right-click on My Computer, and then select Manage in the pop-up menu to
display the Computer Management screen.