Specifications

11 / 13
Integration instructions for host product manufacturers according to KDB 996369 D03
OEM Manual v01
2.2 List of applicable FCC rules
FCC Part 15 Subpart C 15.247 & 15.209 &15.407.
2.3 Specific operational use conditions
The module can be used for mobile applications with a maximum 4.84dBi antenna. The host
manufacturer installing this module into their product must ensure that the final compos it
product complies with the FCC requirements by a technical assessment or evaluation to the
FCC rules, including the transmitter operation. The host manufacturer has to be aware not to
provide information to the end user regarding how to install or remove this RF module in the
user's manual of the end product which integrates this module. The end user manual shall
include all required regulatory information/warning as show in this manual.
2.4 Limited module procedures
Not applicable. The module is a Single module and complies with the requirement of FCC
Part 15.212.
2.5 Trace antenna designs
Not applicable. The module has its own antenna, and doesn.t need a host. sprinted board
microstrip trace antenna etc.
2.6 RF exposure considerations
The module must be installed in the host equipment such that at least 20cm is maintained
between the antenna and users‟ body; and if RF exposure statement or module layout is
changed, then the host product manufacturer required to take responsibility of the module
through a change in FCC ID or new application. The FCC ID of the module cannot be used on
the final product. In these circumstances, the host manufacturer will be responsible for re-
evaluating the end product (including the transmitter) and obtaining a separate FCC
authorization.
2.7 Antennas
Antenna Specification are as follows:
Type: FPC Antenna
Gain: 4.84dBi Max.
This device is intended only for host manufacturers under the following conditions:
The transmitter module may not be co-located with any other transmitter or antenna;
The module shall be only used with the internal antenna(s) that has been originally tested and
certified with this module. The antenna must be either permanently attached or employ a
„unique‟ antenna coupler.
As long as the conditions above are met, further transmitter test will not be required.
However, the host manufacturer is still responsible for testing their end-product for any
additional compliance requirements required with this module installed (for example, digital
device emissions, PC peripheral requirements, etc.).
2.8 Label and compliance information
Host product manufacturers need to provide a physical or e-label stating “Contains FCC ID:
SMQALX850B” with their finished product