User Guide

6 / 14
3.1 Application Usage
Theapplication
can be started inthe following manner:
#cdrelease
#./transmit<g> <r> <l> <m><c> <p> <f><a> <n> <d><g> referstoTx gainvalue for co
ntrollingtransmit
power.
<r> refers to Tx Rate.
<l> refers to length of the Tx packet
<m> referstoTransmit mode.
0
– Burst Mode
1
– Continuous Mode
<c> refers to Channel number
<p> referstoExternal PA-Enable/disable
<f> refers to Short GI, Greenfield and Channel Width.
<a> refers toenable/disable aggregation
<n>refersto number of packets to send in burst mode.
<d> referstodelay between packets in burst mode
After starting this application, user hastoenterthefollowing command to
stop the ongoing transmission:
#./transmit<m>
<m> - 0for Burst Mode
1for Continuous
Mode
S
et power value:
To
set Tx gain value, enter a valid
value
for <p> parameter. The validvaluesarefrom 229 to255forRS9113module
U.
The transmit
power increases proportionatelywith increase in Tx gainvalue in OFDM andCCK
modes. This support is notpresent inthis release.
S
etData Rate:
To
set transmit data rate, enter a valid ratefor <r> parameter.
Valid values are (1,2,5.5,11,6,9,12,18,24,36,48,54,mcs0,mcs1,
mcs2,
mcs3, mcs4,mcs5,mcs6, mcs7).