User Guide

5 / 14
When driveris compiled in “host” directorydriver wouldbeusingbinaries from “release ”.
If thereare any modifications in “host” directory then drivercompilation is required.
TheRS9113 driverofferstwo
main modes of operation:
1.
End-end, orWi-Fi mode
2.
PER mode for PHY evaluation
To configure thedriver in Wi-Fi or (END-to-END) Mode make
suretohavethefollowing
linein “release/insert.sh ”.
DRIVER_MODE = 1
In order toconfigurethedriverin PHY Evaluationmode(PER mode)then make sure the “DRI
VER_MODE”parametershould beset
asDRIVER_MODE = 2
3. Transmit Tests
In general, before performing any tests configure
the
PHY to operate inthe appropriate band.The transmit tests can be performedthrough a
utility called‘transmit ’ whichis found under ‘release’directory.
Configure
the following parameters through this application before runningthe tests.
Transmit power
฀ Transmit data rate
฀ Packet length
฀ Transmit mode
฀ Channel number
฀ External PA-Enable/Disable
฀ Rate flags
฀ Aggregation flag
฀ Number of packets to send in burst mode
฀ Delay between the packets in burst mode