User Guide

4 / 14
The‘transmit’
utilityis a command lineapplicationto perform Tx tests. Before running
the
Tx tests,the useris expected to connect RS9113 ™ toasignal analyzer using
the RF cable.
The‘receive’
utility is also a separate command line applicationthat can beusedfor
displaying statistics on the received packetswhilecarrying outthe receive sensitivity
tests.
Please
follow “ RS9113-SW-Installation-
Guide
” forbuilding and installingthe RS9113 ™ driver.
To
configure thedriver in “PER” Mode make sure to have the
following
line in“release/insert.sh”.
DRIVER_MODE = 2
After the card has been detected successfully(issue“ dmesg–
c”
in terminalto check thestatus for the USB card itwill show “ new high-
speed USB devicedetection ”while for the SDIO it will show “new High speed SDIO card
detected”)the
Tx and Rx tests can be started.Pleasefollowthe subsequent sections for
executing the Txand Rx tests
Figure 3: Utility Diagram