Data Sheet

the host equipment is no longer considered valid and the FCC ID of the module cannot be used on
the final product. In these circumstances, the OEM integrator will be responsible for re-evaluating
the end product (including the transmitter) and obtaining a separate FCC authorization.
Antennas
The module doesn’t have onboard antenna, but has an antenna connector which is compatible
with I-PEX 1 standard.
Label and compliance information
The final end product must be labeled in a visible area with the following: “Contains FCC ID: 2A3GI-
EDGW1303S”. Information that must be placed in the end user manual:
The OEM integrator has to be aware not to provide information to the end user regarding how to
install or remove this RF module in the user's manual of the end product which integrates this
module. The end user manual shall include all required regulatory information/warning as show in
this manual. The module not applicable Limited module procedures. The module is a Single module
and complies with the requirement of FCC Part 15.247
Warning: Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to IC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio, which can be determined by turning the equipment off and on.
Information on test modes and additional testing requirements
To investigate the maximum EMI emission characteristics generates from EUT, the test system was
pre-scanning tested base on the consideration of following EUT operation mode or test
configuration mode which possible have effect on EMI emission level. Each of these EUT operation
mode(s) or test configuration mode(s) mentioned above was evaluated respectively.
RADIATED EMISSION TEST (BELOW 1GHz):
Pre-Scan has been conducted to determine the worst-case mode from all possible combinations
between available modulations, data rates, XYZ axis and antenna ports (if EUT with antenna
FCC ID: XXX-XXX