Installation Guide

17
INSTALLATION INSTRUCTIONS (Undermount Sink)
WARNING
Vanity (A) MUST be secured to wall.
Note: Clean area where the vanity (A) will be
permanently located prior to beginning installation,
ensuring the vanity (A) will not interfere with any
water supply and drain lines once mounted.
3. With two people, carefully place vanity (A)
against the wall in its final location.
While holding the vanity base firmly against the
wall, use the pre-assembled levelers on the
bottom of each leg of the vanity (A) to level the
item. Twisting the levelers counterclockwise
will raise the height of the vanity (A), and
twisting them clockwise will lower the vanity.
Once the vanity is in place, against the wall,
and level from front to back and side to side,
drill a hole through the vanity mounting area
and into the wall studs (as illustrated in
diagram 3). Using appropriate mounting
hardware (not included), secure the vanity (A) to
a wall stud. If possible, secure the vanity (A) to two wall studs for increased stability.
3
1
2
A
4. Take out the top (B) and backsplash (C)
according to the steps indicated by the
drawings on the right, and place them face
down onto a scratch free surface such as a
foam sheet that came in the packaging.
4
Remove the top foam sheet
Remove the backsplash and place
it on a scratch free surface
C
Foam sheet
C
Remove the foam sheet
B
BACK
FRONT
BACK
FRONT
Remove the top and place it
on a scratch free surface
B
BACK
FRONT
BACK
FRONT
Foam sheet
Remove the cutout foam
sheet & hardware
1
2
1
2
B
Hardware
Pack
Hardware
Pack