Installation Guide

INSTALLATION INSTRUCTIONS (Semi-Recessed Sink)

PREPARATION

Before beginning assembly of product, make sure all parts are present. Compare parts with

package contents list and hardware contents list. If any part is missing or damaged, do not attempt

to assemble the product.

Estimated Installation Time: 45 minutes (24 hours for silicone caulk to dry).

Tools Required for Installation (not included): Phillips screwdriver, utility knife or scissors, silicone

caulk, power drill with drill bit, measuring tape, level

WARNING

Vanity (A) MUST be secured to wall.

Note: Clean area where the vanity (A) will be

permanently located prior to beginning installation,

ensuring the vanity (A) will not interfere with any

water supply and drain lines once mounted.

2. With two people, carefully place vanity (A)

against the wall in its final location.

While holding the vanity base firmly against the

wall, use the pre-assembled levelers on the

bottom of each leg of the vanity (A) to level the

item. Twisting the levelers counterclockwise

will raise the height of the vanity (A), and

twisting them clockwise will lower the vanity.

Once the vanity is in place, against the wall,

and level from front to back and side to side,

drill a hole through the vanity mounting area

and into the wall studs (as illustrated in

diagram 2). Using appropriate mounting

hardware (not included), secure the vanity (A) to

a wall stud. If possible, secure the vanity (A) to two wall studs for increased stability.

1. As shown in the diagram, fully extend the

drawer and locate the plastic levers on the

metal glide tracks. Push the left-side and

right-side levers at the same time to

disengage the drawer from the drawer glides.

Gently lift the drawer up to remove it from

vanity (A).