User Manual

8
EN
OPERATION
• ALWAYSturnonyourtransmitterbeforeyouturnonthe
receiver in the vehicle. Always turn off the receiver before
turning your transmitter off.
• ALWAYSoperateyourvehicleinawideopenarea.Operatingthe
vehicle in a small space or indoors can cause overheating at
lowspeeds.Operatingatlowspeedincreasesheatinthe
electronicspeedcontrol(ESC).Overheatingcandamagethe
vehicle and failure may result.
WHEN YOU ARE FINISHED
• Seatthemotorbrushesbydrivingsmoothlyon
a flat surface during use of the first battery charge.
• Prolongmotorlifebypreventingoverheatingconditions.
Unduemotorwearresultsfromfrequentturns,stopsand
starts, pushing objects, driving in deep sand and tall
grass, and driving continuously up hill.
• Over-temperatureprotectionisinstalledontheESCtoprevent
circuit damage, but cannot protect the motor from driving
against heavy resistance.
MOTOR CARE
1. Power off the Electronic Speed Control (ESC). 2. Disconnect the battery.
4. Remove the battery from the vehicle.
3. Power off the transmitter.
5. Recharge the battery.