User Manual

4
EN
CHARGING THE VEHICLE BATTERY
1. Attach the battery connector to the battery charger as shown.
2. Connect the battery charger to an AC power outlet.
3. Disconnect the battery from the charger as soon as the battery
is done charging.
4.UnplugthebatterychargerfromtheACpoweroutlet.
The vehicle battery charger produces 2.0 Amps 2000 milliAmps
per hour. Divide the mAh capacity on the label of a battery by 2000
toknowhowlongbatterychargingwillrequire.Forexample,an
1800mAh battery requires .9 hours (54 minutes) to charge.
CHARGING WARNINGS AND PRECAUTIONS
Failuretoexercisecautionwhileusingthisproductandcomply
with the following warnings could result in product malfunction,
electricalissues,excessiveheat,FIRE,andultimatelyinjuryand
property damage.
Transmitter
Frequency 2.4GHz
Battery AAx4
Servo
Power Supply 4.8V~6V (shared with receiver)
OutputTorque 41.66oz(3kg-cm)
OperatingSpeed 0.23sec/60degreesoftravel
Size 55.6x18x30mm
Electronic Speed Control (ESC)
Input Voltage 4.8–8.4V
Electric Capacity (FET) Forward 30 A/300 A
Electric Capacity (FET) Reverse 15 A/150 A
PWM Frequency 1kHz
BEC Voltage 5.6 V/1 A
Size 46.4x36.9x28.25mm
Weight 76 g
SPECIFICATIONS
1. ECX
™
Torment
™
1/10-scale Short Course Truck
2. ECX
™
2.4GHz Transmitter
3. AA (4) Batteries
4. DYN4113 2A Peak Battery Charger
5. Dynamite
®
Speedpack
™
7.2V Ni-MH battery
(DYN1050EC)
COMPONENTS
1
2
5
3
VEHICLE PREPARATIONS
•Readallsafetyprecautionsandliteraturepriortouse
of this product.
•Neverallowminorstochargebatterypacks.
•Neverattempttochargedeadordamagedbatteries.
•Neverchargeabatteryifthecablehasbeenpinchedorshorted.
•Neverallowbatteriesorchargerstocomeintocontactwith
moisture at any time.
•Neverchargebatteriesinextremelyhotorcoldplaces
(recommended between 50–80°F or 10–26°C) or place
in direct sunlight.
•AlwaysuseonlyNi-MHrechargeablebatteries.Thischarger
cannot charge batteries such as “heavy duty,” “alkaline battery,”
or “mercury battery.”
•Alwaysconnectthepositiveredlead(+)andnegativeblack
lead (-) terminals of the battery to the charger terminals correctly.
•Alwaysdisconnectthebatteryandchargeraftercharging
and let them cool between charges.
•Alwaysinspectthebatterybeforecharging.
•AlwaysterminateallprocessesandcontactHorizonHobby
if the product malfunctions.
•Alwaysmakesureyouknowthespecificationsofthebattery
to be charged or discharged to ensure it meets the requirements
of this charger.
•Neverconnectmorethanonebatterypacktothischarger
at a time.
•Alwaysconstantlymonitorthetemperatureofthebattery
pack while charging.
•Alwaysendthechargingprocessifthechargerorbatterybecomes
hot to the touch or starts to change form during the charge process.
4