Instruction manual

9
RUCKUS
EN
SHOCK CLEANING
• Oil-fi lled shocks will require regular maintenance due to the oil
breaking down or getting dirty. This maintenance should be
performed after about every 3 to 5 hours of use depending on
conditions that the vehicle is used in.
• Remove the shock from the vehicle.
• Remove the cap from the shock body and dispose of fl uid.
• Disassemble the shock. Clean thoroughly with DYN5505. Dry parts
before assembly.
• Assemble the shock and refi ll the shock body with silicone fl uid (30
weight recommended).
• Slowly move the shaft and piston up and down to remove
air bubbles.
• Move the piston to the midway point of the body and install
the cap.
• Wipe off any overfl owing fl uid.
• When properly fi lled, the piston should rebound about 3/8 in
(9.5mm) after being pushed in fully.
• Install shock on vehicle.
Ride Height Adjustment
Ride height is an adjustment that affects the way the vehicle jumps,
turns and goes over bumps. Drop one end of the vehicle from
approximately 6 inches (152 mm) in height onto a fl at surface. When
dropping the front of the vehicle, after the vehicle settles make sure
the front arms are equal and parallel to the fl at surface. Do the same
with the rear and look at the rear to make sure both arms are
parallel with the fl at surface.
Lower the front ride height to increase steering. Lower the rear ride
height to increase traction but decrease steering.
ECX1043
ECX1037
ECX1037
ECX1041
ECX1037
ECX1043
ECX1036
ECX1038
ECX1038
ECX1043
ECX1037
ECX1037
ECX1038
ECX1042
ECX1040
ECX1057
ECX1037
ECX1043
ECX1038
ECX1039
ECX1036
ECX1038
ECX1038
ECX1037
ECX1057
REAR SHOCK FRONT SHOCK
Part # Description
ECX1036 Shock Body Set
ECX1037 Shock Caps, Pistons
ECX1038 Shock Parts Set
ECX1039 Front Shock Shaft (2)
ECX1040 Rear Shock Shaft (2)
ECX1041 Front Shock Springs (2)
ECX1042 Rear Shock Springs (2)
ECX1043 Shock O-Ring Set
MAINTENANCE
No. Description
TAPPING BINDER HEAD M3x10mm
TAPPING BINDER HEAD M3x12mm
TAPPING FLAT HEAD M3x15mm
TAPPING FLAT HEAD M3x12mm
TAPPING FLAT HEAD M3x10mm
TAPPING BINDER HEAD M3x18mm
TAPPING FLAT HEAD M2x16mm
TAPPING BINDER HEAD M3x16mm
No. Description
WASHER 5x7x0.5mm
E-CLIP E2.5
LOCK WASHER
FLANGED LOCK NUT M4
WASHER 3x8x0.5mm
LOCK NUT M3
WASHER 2x7x0.5mm
SET SHAFT SCREW M3x13mm
No. Description
BUTTON HEX M2.5x4mm
SET SCREW M3x3mm
SET SCREW M3x12mm
STEP SCREW M3x0.5x13.4mm
STEP SCREW M3x0.5x10.5mm
BUTTON HEX M2.5x8mm
STEP SCREW M3x0.5x7.4mm
No. Description
BINDER HEAD M3x8mm
BINDER HEAD M3x12mm
BINDER HEAD M3x20mm
BINDER HEAD M3x25mm
BUTTON HEAD M3x30mm
BUTTON HEAD M2x6mm
TAPPING BUTTON HEAD M3x10mm
FASTENERS