RUCKUS TM 1/10 ELECTRIC MONSTER TRUCK ECX2000 | ECX2000AU | ECX2000EU | ECX2000UK ECX2100 | ECX2100AU | ECX2100EU | ECX2100UK INSTRUCTION MANUAL BEDIENUNGSANLEITUNG MANUEL D’UTILISATION MANUALE Congratulations on your purchase of the Electrix RCTM RuckusTM Monster Truck. This 1/10 scale model introduces you to the sport of RC driving. Herzlichen Glückwunsch zum Kauf des Electrix RCTM RuckusTM Monster Truck. Dieses 1/10 Scale Model öffnet Ihnen die Welt des RC Car Sports.
EN NOTICE All instructions, warranties and other collateral documents are subject to change at the sole discretion of Horizon Hobby, Inc. For up-to-date product literature, visit http://www.horizonhobby.com and click on the support tab for this product.
EN SPECIFICATIONS Receiver Transmitter Frequency Modulation Battery Current Consumption Size Weight 27MHz Pulse Proportional Modulation (PPM) AA x 8 200mAh 17 x 23.5 x 7.5mm 382 g Servo Power Supply Output Torque Operating Speed Size Frequency Intermediate Frequency Current Consumption Weight 27MHz 445kHz 18mAh 15 g Electronic Speed Control (ESC) Input Voltage Electric Capacity (FET) Electric Capacity (FET) PWM Frequency BEC Voltage Size Weight 4.8V~6V (shared with receiver) 41.66 oz (3 kg-cm) 0.
EN INSTALLING TRANSMITTER BATTERIES 1. Slide panel open on bottom of transmitter. 2. Obey battery plus (+) and minus (-) diagram in transmitter to install 8 AA batteries. 3. Slide panel closed on transmitter. WARNING: ALWAYS use fully charged batteries in the transmitter. Low battery power can result in loss of control of the RC vehicle. NEVER install damaged batteries, batteries of mixed types or batteries of different ages in the transmitter. Remove exhausted batteries.
EN INSTALLING VEHICLE BATTERY • Turn the thumb nuts on the chassis to remove the battery strap holding the battery. Remove or install a battery and replace the battery strap, locking the strap in place by turning the thumb nuts. • You can put the foam blocks (ECX2015) in front of the battery so the weight of the battery increases rear traction or in back of the battery to increase steering response. OPERATION ALWAYS turn on your transmitter before you turn on the receiver in the car.
EN TRANSMITTER CONTROLS AM 27MHZ TRANSMITTER CRYSTAL REVERSE SWITCH ANTENNA Pull antenna out to its full length (ECX1067 Antenna Only) Part # ECX1081 ECX1082 ECX1083 ECX1084 ECX1085 ECX1086 Description Crystal Set 1 26.995 Crystal Set 2 27.045 Crystal Set 3 27.095 Crystal Set 4 27.145 Crystal Set 5 27.195 Crystal Set 6 27.255 AM Transmitter Crystal (Tx) AM Receiver Crystal (Rx) AM Rx AM Tx Note: Paired AM crystals must be replaced to change control frequencies. Do NOT use FM Crystals.
EN GETTING STARTED 1. Fully extend Antenna and Power on Transmitter. 2. Connect battery (page 3) to Electronic Speed Control (ESC) and power on the ESC. 3. Do a Test of Transmitter’s control of vehicle with vehicle wheels off ground. 4. Start driving slowly and if the vehicle does not go straight, adjust steering trim dial on Transmitter. Note: Seat motor brushes by driving smoothly on a flat surface during use of the first battery charge. WHEN YOU ARE FINISHED 1.
EN SETTING THE GEAR MESH Gear mesh has already been set at the factory, and setting it is only necessary when changing motors or gears. Note: You must remove the vehicle’s gear cover (A) to do this adjustment. Proper gear mesh (how gear teeth meet) is important to the performance of the vehicle. When gear mesh is too loose, the spur gear could be damaged by the pinion gear of the motor. If the mesh is too tight, speed could be limited and the motor and ESC will overheat. A 1.
EN MAINTENANCE SHOCK CLEANING REAR SHOCK ECX1037 • Oil-filled shocks will require regular maintenance due to the oil breaking down or getting dirty. This maintenance should be performed after about every 3 to 5 hours of use depending on conditions that the vehicle is used in. • Remove the shock from the vehicle. • Remove the cap from the shock body and dispose of fluid. • Disassemble the shock. Clean thoroughly with DYN5505. Dry parts before assembly.
EN TROUBLESHOOTING GUIDE Problem Possible Cause Solution Short Run Time • Battery damaged/not charged • Motor dirty or brushes worn • Check/change battery • Check/clean/replace Sluggish Action •Motor dirty or brushes worn • Bind in drivetrain • Vehicle battery is not charged • Check/clean/replace • Clean/adjust • Replace/recharge Controls Reversed • ST. REV or TH.
EN sales receipt verifying the proof-of-purchase date. Provided warranty conditions have been met, your Product will be repaired or replaced free of charge. Repair or replacement decisions are at the sole discretion of Horizon. Non-Warranty Repairs Should your repair not be covered by warranty the repair will be completed and payment will be required without notification or estimate of the expense unless the expense exceeds 50% of the retail purchase cost.
PARTS DIAGRAM | EXPLOSIONSZEICHNUNG | VUE ÉCLATÉE DES PIÉCES | ESPLOSO DEL MODELLO CON REFERENZA PEZZI Recommended Items Empfohlene Werkzeuge Outils Recommandés Attrezzi raccomandati M3X10 M3X12 30 3 11 46 M3X10 10 M3X10 5 12 M3X12 9 1 M3X12 M3X12 M3X12 M3X25 M3X10 M3X12 12 20 45 20 4 7 12 7 2 2 46 2 8 50 M3X15 M3X10 2 8 17 16 2 2 7 19 2 M3X12 20 2 7 8 13 19 M3x15 29 18 20 M3X10 13 M3x15 47 23 31 M3x25 32 8 7 21 15 15 13 M3X8 M3X12 19 M3X10 42 RUCKU
PARTS DIAGRAM | EXPLOSIONSZEICHNUNG | VUE ÉCLATÉE DES PIÉCES | ESPLOSO DEL MODELLO CON REFERENZA PEZZI Note: The slipper clutch can be adjusted using this locknut (ECX1060). Fully tighten the locknut. Then loosen the nut two full turns. Die Rutschkupplung kann durch diese Stopmutter eingestellt werden (ECX1060). Ziehen Sie die Mutter an und drehen Sie dann volle zwei Umdrehungen zurück. A noter: Il est possible d’ajuster l’embrayage “patinant” par action sur cet écrou de blocage (ECX1060).
Part # | Nummer Numéro | Codice Description Beschreibung Description Descrizione 1 ECX2008 Main Chassis Chassis Châssis principal Telaio principale 2 ECX1028 Servo Saver Set Servo Saver Set Jeu de sauvegarde de servo Set salvaservo 3 ECX2011 Cover and Rear Mount Set 4 ECX1050 Setscrew M3x12 (4) Schrauben Set M3x12 (4) 5 ECX2015 Foam Block Schaum Block Bloc de mousse Spugna distanziale batteria 6 ECX1052 Motor Screw/Washer Set Motor Screw/Washer Set Vis Moteur/Set Rondelles
NOTES / HINWEIS / A NOTER / NOTA RUCKUS 45
NOTES / HINWEIS / A NOTER / NOTA 46 RUCKUS
NOTES / HINWEIS / A NOTER / NOTA RUCKUS 47
Created 10/10 22425.1 ECX2000, ECX2000UK, ECX2000EU, ECX2000AU ECX2100, ECX2100UK, ECX2100EU, ECX2100AU © 2010 Horizon Hobby, Inc.
