Instruction manual

7
EN
GETTING STARTED
8. Start driving slowly, and, if the vehicle does not go straight,
adjust the steering trim dial on the transmitter.
Allmodelcarenginesmustuseaproperlyoiledairltertokeepdirt
out of the engine. Any dirt that enters the carburetor can damage your
engine.Cleanandre-oiltheairlteraftereachhourofusetoprevent
dirt from entering the engine. If you intend to run your vehicle
inextremelydustyconditions,theairltershouldbeserviced
after every 1/2 hour.
6. Do a test of the transmitter’s control of the vehicle
with the vehicle’s wheels off the ground.
5. Fill the fuel tank with nitro
fuel and power on the receiver.
POWER
ST. TRIM
TH. TRIM
ST. RATE
4. Power on the transmitter.
7. Start the vehicle according
to the instructions on the
following page.
Fuel Storage Precautions and Guidelines
• Whenfinishedrunningyourvehicle,alwaysrunyourengineuntil
the fuel tank is empty. Do not store the vehicle with fuel in the
engine.
• Neverhandlemodelenginesandmufflersuntiltheyhavehadtime
tocool.Theybecomeextremelyhotwheninuse.
• Alwaysstoreyourfuelinasafeplacewellawayfromsparks,
heat or anything that can ignite.
• Alwaysensurethatfuelisstoredinaclearlymarkedcontainer
well away from the reach of children.
• Alwaysstoreyourfuelsafelyinasealed,water-resistantcontainer
specifically made for gasoline.
• Alwaysstorefuelinacool,drylocation,outofdirectsunlight.Do
not allow fuel containers to come in direct contact with concrete,
as the fuel may absorb moisture.
•Alwaysresponsiblydiscardfuelifthereiscondensationand/or
water inside the fuel container.
• Neverallowfueltocomeintocontactwitheyesormouth.
Fuels used in model engines are poisonous.
• Neverreturnunusedfuelfromthefueltankbackinto
the fuel container.
(wire tie)
(wire tie)
1. Assemble the air filter. Install the
wire tie at the 5 position, ensuring
that the wire tie is secure.
2. Remove the rubber cap from
the carburetor inlet.
3. Install the air filter onto the
carburetor inlet. Install the
wire tie at the 6 position,
ensuring that it is secure.