Instruction manual

4
EN
1
Transmitter
Frequency 2.4GHz
Modulation DSM, DSM2, Marine
Battery AAx4
SPECIFICATIONS
COMPONENTS
VEHICLE PREPARATIONS
Included Items
1. ECX
™
Revenge Type N
™
1/8-scaleNitroOff-RoadBuggy
2. Spektrum
™
DX2E 2.4GHz transmitter
• 3degreetoeset
• Shockspacers
• Airfilterassembly
• Turnbucklewrench
• Lwrenches:1.5,2and2.5mm
Needed to Complete
• Nitrofuel
• Glow igniter
• 8AA batteries
• Neverinstalldamagedbatteries.
• Neverinstallbatteriesofmixedtypesorofdifferentages
in the transmitter.
• Alwaysremoveexhaustedbatteries.
• Alwaysremovebatteriesbeforestoringthetransmitter.
• LowbatterypowercanresultinlossofcontroloftheRCvehicle.
TRANSMITTER BATTERY SAFETY PRECAUTIONS
1. Slide the panel open on the bottom of the
transmitter.
2. Obeythebatteryplus(+)andminus(-)diagram
in the transmitter to install 4 AA batteries.
3. Slide the panel closed.
We recommend using only alkaline AA batteries
in the transmitter, however, it is possible to use
rechargeable Ni-MH batteries.
CAUTION: If using rechargeable batteries, charge
only rechargeable batteries. Charging non-rechargeable
batteries may cause the batteries to burst, resulting in
injury to persons and/or damage to property.
INSTALLING TRANSMITTER BATTERIES
31 2
2
POWER
ST. TRIM
TH. TRIM
ST. RATE
Steering Servo
Power Supply 4.8V~6V (shared with receiver)
OutputTorque 199.8oz-in(8.5kg-cm)
OperatingSpeed 0.20sec/60degreesoftravel
Size 55.6x18x30mm
Throttle Servo
Power Supply 4.8V~6V (shared with receiver)
OutputTorque 41.66oz-in(3kg-cm)
OperatingSpeed 0.23sec/60degreesoftravel
Size 55.6x18x30mm