Instruction manual

6
EN
1.Obeythebatteryplus(+)andminus(-)diagraminthebattery
holder to install 4 AA batteries.
2. Remove the clip and raise the battery hold down.
3.Installthebatterybox.
4. Lower the battery hold down and reinstall the clip.
5.ConnectthebatteryboxtotheReceiver/ESCunit.
ON
TIP: Seat the motor brushes by driving smoothly on a flat surface
duringuseoftherstbatterycharge.Properlyseatingthemotor
brushes will increase the life and performance of the motor.
INSTALLING VEHICLE BATTERY HOLDER
GETTING STARTED
1. Power on the transmitter.
2.ConnectthebatteryboxtotheElectronicSpeedControl(ESC)/
Receiver unit and power on the vehicle.
3.Doatestofthetransmitter’scontrolofthevehiclewith
the vehicle’s wheels off the ground.
4. Start driving slowly and if the wheels are not straight,
adjust the steering trim dial on the transmitter.