Instruction manual

1. Slide the panel open on the bottom of the transmitter.

2.Obeythebatteryplus(+)andminus(-)diagraminthetransmitter

to install 8 AA batteries.

3.Slidethepanelclosed.

We recommend using only alkaline AA batteries

in the transmitter.

CAUTION: If using rechargeable batteries, charge only

rechargeable batteries. Charging non-rechargeable batteries

may cause the batteries to burst, resulting in injury to persons

and/or damage to property. Low battery power can result in

loss of control of the RC vehicle.

NEVERinstalldamagedbatteries,batteriesofmixedtypes

or batteries of different ages in the transmitter. Remove

exhaustedbatteries.

NEVER store the transmitter with batteries installed.

INSTALLING TRANSMITTER ANTENNA

1. Put the antenna in the hole in top of the transmitter.

2. The collapsed antenna will be 4.25 inches long when

fully inserted.

3.Turntheantennaclockwiseuntilitistight.

VEHICLE PREPARATIONS

INSTALLING TRANSMITTER BATTERIES

INSTALLING TRANSMITTER ANTENNA

INSTALLING ANTENNA TUBE AND BODY

1.BodyClips(ECX8323)

2.Antenna(ECX1087)