User Manual

7
EN
CIRCUIT
™
• ALWAYS turn on your transmitter before you turn on the receiver
in the vehicle. Always power off the receiver before turning your
transmitter off.
• ALWAYS operate your vehicle in a wide open area. Operating the
vehicle in a small space or indoors can cause overheating at low
speeds. Operating at low speed increases heat in the electronic
speed control (ESC). Overheating can damage the vehicle and failure
may result.
OPERATION
WHEN YOU ARE FINISHED
• Seat the motor brushes by driving smoothly on a flat surface during
use of the first battery charge. Failing to do so can greatly
reduce motor performance and functional life.
• Prolong motor life by preventing overheating conditions.
Undue motor wear results from frequent turns, stops and starts,
pushing objects, driving in deep water and tall grass, and driving
continuously up hill. Allow the motor to cool completely
before running the vehicle.
• Over-temperature protection is installed on the ESC to prevent
circuit damage, but cannot protect the motor from driving against
heavy resistance.
MOTOR CARE
1. Power off the ESC. 2. Disconnect the battery.
4. Remove the battery from the vehicle.
3. Power off the transmitter.
5. Recharge the battery.