User Manual

6
EN
1/10 2WD Electric Monster Truck
1. Power on the transmitter.
3. Perform a test of the transmitter’s control of the vehicle with
the vehicle’s wheels off the ground.
4. Start driving slowly, and, if the vehicle does not go straight,
adjust the steering trim dial on the transmitter.
IMPORTANT: Seat the motor brushes by driving smoothly on a fl at
surface during use of the fi rst battery charge. Properly seating the motor
brushes will increase the life and performance of the motor.
2. Power on the ESC.
BINDING
The included transmitter and receiver are bound at the factory.
If you need to rebind, follow the instructions below.
1. Power ON the receiver. The receiver LED fl ashes slowly.
2. Insert the bind plug into the receiver’s binding pins.
The receiver LED flashes rapidly.
3. Power ON the transmitter.
4. The receiver LED turns solid when binding is successful.
Remove the bind plug.
You must rebind when binding the receiver to a different transmitter.
NOTICE: Do not attempt to bind the transmitter and receiver if there
are other compatible transmitters in bind mode within 400 feet. Doing
so may result in unexpected binding.
GETTING STARTED