User Manual

ManualsBrandsECX ManualsCars & Trucks1/10 Amp Crush 2WD Monster Truck Brushed RTR, Orange

1/10 2WD Electric Monster Truck

QUICK START

Please read the entire manual to gain a full understanding of the vehicle, ﬁ ne-tuning the setup and performing maintenance.

1. Read the safety precautions found in this manual.

2. Charge a battery for the vehicle. Refer to the included charging

warnings and instructions for battery charging information.

3. Install the AA batteries in the transmitter. Only use alkaline or

rechargeable batteries.

4. Install the fully charged battery in the vehicle.

5. Power ON the transmitter and then the vehicle. Wait 5 seconds for the

ESC to initialize. Always power the transmitter ON before the vehicle and

power it OFF after the vehicle has been powered OFF.

6. Check the steering and throttle control directions. Verify that the servos

are moving in the correct direction.

7. Drive your vehicle.

8. Perform any necessary maintenance.

VEHICLE PREPARATIONS

CHARGING THE VEHICLE BATTERY

NOTICE: Never charge a battery in the vehicle or damage may result.

1. Connect the NiMH battery to the battery charger.

2. Connect the charger to an AC power outlet.

3. Allow the NiMH battery to charge for 9 hours.

CHARGING WARNINGS

WARNING: Failure to exercise caution while using this product and

comply with the following warnings could result in product malfunction,

electrical issues, excessive heat, FIRE, and ultimately injury and property

damage.

• NEVER LEAVE CHARGING BATTERIES UNATTENDED.

• NEVER CHARGE BATTERIES OVERNIGHT.

• Read all safety precautions and literature prior to use of this product.

• Never leave the battery and charger unattended during use.

• Never allow children under 14 years of age to charge battery packs.

• Never attempt to charge dead or damaged batteries.

• Never charge a battery if the cable has been pinched or shorted.

• Never allow batteries or charger to come into contact with moisture at any time.

• Never charge batteries in extremely hot or cold places (recommended

between 50–80°F [10–26°C]) or place in direct sunlight.

• Always use only Ni-MH rechargeable batteries. This charger cannot charge

batteries such as “heavy duty,” “alkaline,” “mercury” or “lithium” battery.

• Always connect to the charger correctly.

• Always disconnect the battery and charger after charging and let them cool

between charges.

• Always inspect the battery before charging.

• Always terminate all processes and contact Horizon Hobby if the product

malfunctions.

• Always make sure you know the specifications of the battery to be charged

or discharged to ensure it meets the requirements of this charger.

• Always constantly monitor the temperature of the battery pack while charging.

• Always end the charging process if the charger or battery becomes hot to

the touch or starts to change form during the charge process.

• Always charge in a well ventilated area.

INSTALLING THE BATTERY

1. Turn the battery clips (A) clockwise to remove the battery strap (B).

2. Install a fully charged battery.

3. Install the battery strap.

4. Turn the battery clips counterclockwise to secure the battery strap.

Place foam blocks (ECX236005) in front of the battery so the weight of the

battery increases rear traction or in back of the battery to increase steering

response.

CAUTION: Connecting the battery to the ESC with reversed po-

larity will cause damage to the ESC, the battery or both. Damage

caused by incorrectly connecting the battery is not covered under warranty.