User Manual

3
EN
Instruction Manual
SPECIFICATIONS
TABLE OF CONTENTS
Water-Resistant Vehicle with Waterproof Electronics ................................2
Specifi cations .......................................................................................3
Components .........................................................................................3
Quick Start ............................................................................................4
Vehicle Preparations ...............................................................................4
Charging the Vehicle Battery ................................................................4
Charging Warnings ..............................................................................4
Installing the Battery ...........................................................................4
Transmitter Controls ............................................................................5
Installing the Transmitter Batteries ........................................................5
Binding...............................................................................................6
Getting Started ......................................................................................6
Operation ..............................................................................................7
When You Are Finished ...........................................................................7
Motor Care ............................................................................................7
Maintenance ..........................................................................................8
Setting the Gear Mesh .........................................................................8
Electrical Layout ..................................................................................8
Shock Cleaning ...................................................................................9
Ride Height Adjustment .......................................................................9
Shock Absorber Parts ..........................................................................9
Fasteners ...........................................................................................9
Troubleshooting Guide ..........................................................................10
Limited Warranty ..................................................................................11
Warranty and Service Contact Information .............................................12
FCC Information ...................................................................................12
IC Information ......................................................................................12
EU Compliance Statement ....................................................................12
Parts Diagram ................................................................................46–48
Replacement Parts ...............................................................................49
Optional Parts ......................................................................................50
Recommended Parts ............................................................................50
Transmitter (ECX10003)
Frequency 2.4GHz
Battery AA × 4
Servo (SPMS603)
Power Supply 4.8V~6V
Output Torque 41.66 oz (3 kg-cm)
Operating Speed 0.23sec/60 degrees of travel
Size 55.6 × 18 × 30mm
Electronic Speed Control/Receiver (ECX13010)
Input Voltage 6–8.4V (NiMH Only)
Electric Capacity 20A
BEC Voltage 6V, 2A
Size 63.7 x 23.5 x 36.1mm
Weight 1.41 oz (40 g)
Wet Conditions Maintenance
• Remove the battery pack(s) and dry the contacts. If you have an air
compressor or a can of compressed air, blow out any water that may be
inside the recessed connector housing.
• Remove the tires/wheels from the vehicle and gently rinse the mud and dirt
off with a garden hose. Avoid rinsing the bearings and transmission.
NOTICE: Never use a pressure washer to clean your vehicle.
• Use an air compressor or a can of compressed air to dry the vehicle and help
remove any water that may have gotten into small crevices or corners.
• Spray the bearings, drive train, fasteners and other metal parts with a water-
displacing light oil or lubricant. Do not spray the motor.
• Let the vehicle air dry before you store it. Water (and oil) may continue to drip
for a few hours.
• Increase the frequency of disassembly, inspection and lubrication of the
following:
• Front and rear axle hub assembly bearings.
• All transmission cases, gears and differentials.
• Motor—clean with an aerosol motor cleaner and re-oil the bushings
with lightweight motor oil.
COMPONENTS
• ECX
®
Amp Crush
™
(ECX03048)
• ECX
®
2.4GHz Transmitter (ECX10003)
• AA (4) Batteries
• Speedpack
®
1800mAh Ni-MH 6-Cell Flat w/EC3™ (DYN1050EC)
• ECX
®
ESC/RX 2.4GHz V4 1:10, WP/LiPo (ECX13010)
• Dynamite
®
20T Brushed Motor (DYN1171)
• Spektrum™ 3KG, Plastic Gear Servo, WP, 23T (SPMS603)
• 200mA Wall Charger with EC3 Connector: US
• 200mA Wall Charger with EC3 Connector: INTL