User Manual

6
EN
RUCKUS
®
4WD
4WD
2.4GHZ DIGITAL
RADIO SYSTEM
TRANSMITTER CONTROLS
INSTALLING THE VEHICLE BATTERY
1. Turn the battery door latch counter-clockwise to
release the battery door.
2. Remove the battery door from the vehicle.
3. Connect the battery to the Electronic Speed Control
(ESC) /Receiver unit connector within the battery
compartment.
4. Install the vehicle battery pack as shown.
5. Re-install the battery door.
6. Turn the battery door latch clockwise to secure
the door.
11
12
43
5
6
7
8
9
10
12
1. Steering Wheel Controls direction (left/right) of the model
2. Throttle Trigger Controls speed and direction (forward/brake/
reverse) of the model
3. ON/OFF Switch Turns the power ON/OFF
4. Throttle Limiting Switch Adjusts the throttle limit from
50%, 75%, and 100%
5. TH Rate Adjusts the end point of the throttle
6. TH Trim Adjusts the throttle neutral point
7. TH REV Reverses the function of the speed control when
pulled back or pushed forward
8. ST REV Reverses the function of the steering when the wheel
is turned left or right
9. ST Trim Adjusts the steering center point
10. ST Rate Adjusts the end point of the steering
11. Antenna Transmits the signal to the model
12. Indicator Lights
• Solid red lights—Indicates radio connectivity and
adequate battery power
• Flashing red lights—Indicates the battery voltage is
critically low. Replace batteries