User Manual

8
EN
boost
• ALWAYSturnonyourtransmitterbeforeyouturnonthereceiver
in the vehicle. Always power off the receiver before turning your
transmitter off.
• ALWAYSoperateyourvehicleinawideopenarea.Operatingthe
vehicle in a small space or indoors can cause overheating at low
speeds.Operatingatlowspeedincreasesheatintheelectronic
speedcontrol(ESC).Overheatingcandamagethevehicleand
failure may result.
OPERATION
WHEN YOU ARE FINISHED
•Seatthemotorbrushesbydrivingsmoothlyonaflatsurface
during use of the first battery charge. Failing to do so can
greatly reduce motor peroformance and functional life.
•Prolongmotorlifebypreventingoverheatingconditions.
Unduemotorwearresultsfromfrequentturns,stopsand
starts, pushing objects, driving in deep sand and tall grass,
and driving continuously uphill.
•Over-temperatureprotectionisinstalledontheESCtoprevent
circuit damage, but cannot protect the motor from driving against
heavy resistance.
MOTOR CARE
1. Power off the Electronic Speed Control
(ESC).
2. Disconnect the battery.
4. Remove the battery from the vehicle.
3. Poweroffthetransmitter.
5. Recharge the battery.