User Manual

5
EN
boost
• Neverinstalldamagedbatteries.
• Neverinstallbatteriesofmixedtypesorofdifferentagesinthe
transmitter.
• Alwaysremoveexhaustedbatteries.
• Alwaysremovebatteriesbeforestoringthetransmitter.
• LowbatterypowercanresultinlossofcontroloftheRCvehicle.
TRANSMITTER BATTERY SAFETY PRECAUTIONS
REMOVING THE VEHICLE BODY
A
B
INSTALLING THE BATTERY IN THE
VEHICLE
1. Turn the battery clips (A) clockwise to remove the battery strap (B).
2. Install a fully charged battery.
3. Installthebatterystrap.
4. Turn the battery clips counterclockwise to secure the battery strap.
If desired, you can put foam blocks (ECX2015) in front of
the battery so the weight of the battery increases rear traction
or in back of the battery to increase steering response.
INSTALLING TRANSMITTER BATTERIES
Install 4 AA alkaline batteries into the transmitter, following the
instructions provided for your radio system.
We recommend using only alkaline AA batteries in the transmitter,
however, it is possible to use rechargeable Ni-MH batteries.
CAUTION: If using rechargeable batteries, charge only
rechargeable batteries. Charging non-rechargeable
batteries may cause the batteries to burst, resulting in
injury to persons and/or damage to property.
NEVERinstalldamagedbatteries,batteriesofmixedtypesorbatteries
ofdifferentagesinthetransmitter.Removeexhaustedbatteries.
NEVER store the transmitter with batteries installed.