User Manual

28
EN
STEP 3: PAINT AND STICKER THE BARRAGE BODY SHELL
1. Clean the inside of the Barrage
®
body shell using a small amount of
water and dish soap. Thoroughly rinse and dry the body shell with a
cloth towel.
Tip: Do not use paper towels.
2. Place window masks inside the body shell.
3. Paint the inside of the Barrage body shell.
4. Once the paint is completely dry, remove the over-spray film from the
outside of the body and the window masks from inside the body.
5. Using the chart below, apply the windows, grill, head lights, and tail
lights. Apply additional stickers to customize the Barrage body.
STEP 4: INSTALL THE VEHICLE BATTERY
When the battery is charged, install it into the Barrage chassis.
1. Secure the battery pack using the hook and loop straps.
2. Plug the EC3™ battery connector into the EC3 ESC connector.
They will only plug together in one direction.
3. Install the body shell and secure it with the four body clips.
CAUTION: Connecting the battery to the ESC with
reversed polarity will cause damage to the ESC, the
battery or both. Damage caused by incorrectly connecting the
battery is not covered under warranty.
2
7 8
3
1
4
5
6
9
2
8
7
3
1
10
11
4
5
6
9
12
10 11
12