User Manual

9
SCT
MT
EN
EC3EC3
A
B
C
D
E
F
G
HI
Operation LED Status Sound at Power UP
Stop OFF
Forward Blinks
Forward (full speed) Solid
Reverse Blinks
Brake Blinks
Brake (full brake) Solid
Ni-MH/Ni-Cd Battery 1 Short Beep
2S Li-Po Battery 2 Short Beeps
ESC Ready 1 Long Beep
Battery Low Voltage Blinks
Overheat Blinks
MAINTENANCE
ELECTRONIC SPEED CONTROL (ESC)
Programming: The ESC comes with two jumpers pre-installed
in the REV: ON and BATT: Ni-MH confi gurations.
To disable reverse or change battery type to Li-Po, disconnect the
jumper from the default port and connect it to the desired port.
Power off the ESC, then power it back on.
If the jumpers are lost or not installed, the ESC will default
to REV: ON and BATT: Li-Po.
LED
ELECTRICAL LAYOUT
For correct operation, Throttle and Steering
channels must be used as shown in the wiring
diagram. The motor can be disconnected from
the ESC at the connectors in the wiring.
Part # Description
A DYNS1213 Motor
B Battery
C SPMS605 Waterproof
Steering Servo
D SPMSRX200 Waterproof Receiver
E DYNS2210 Waterproof Electronic
Speed Control (ESC)
F Auxillary channel
G Throttle channel
H Steering channel
I Bind port