User Manual

72
EN
ELECTRONIC SPEED CONTROL (ESC)
Connecting
1. Connect the RED (+) ESC wire to the RED (+) motor wire.
2. Connect the BLACK (–) ESC wire to the BLACK (–) motor wire.
NOTICE: Always disconnect the battery from the ESC when you
have fi nished operating your vehicle. The ESC switch only controls
power to the receiver and servos. The ESC will continue to draw
current when connected to the battery, resulting in possible damage
to the battery through over-discharge.
Calibrating
Ensure proper ESC function by calibrating the ESC to your transmitter inputs.
1. Power OFF the ESC.
2. Ensure your transmitter is powered ON, the throttle is not reversed, the
throttle trim is neutral and the throttle travel range is at 100%.
3. Keep the throttle at neutral and power ON the ESC.
4. The ESC automatically calibrates the throttle range after 3 seconds.
5. One long beep will sound when the ESC is ready to run.
WHEN YOU ARE FINISHED
STEP 6: DRIVE
Power on the transmitter.
1
Power on the ESC.
2
Power off the ESC.
1
Power off the transmitter.
2
Remove and
recharge the
battery pack.
3
Drive!
3