User Manual

71
EN
CAUTION: If using rechargeable
batteries, charge only rechargeable
batteries. Charging non-rechargeable batteries
may cause the batteries to burst, resulting in
injury to persons and/or damage to property.
1. Remove the battery cover from the transmitter.
2. Install four AA batteries as shown.
3. Re-install the battery cover.
4. Review the transmitter controls (below).
The Transmitter and ESC are bound at the factory.
If you need to rebind, follow the BINDING
instructions.
STEP 5: SET UP THE RADIO SYSTEM
CAUTION: Risk of explosion if battery is replaced by an
incorrect type. Dispose of used batteries according to national
regulations.
Solid Red and Green:
Battery voltage is
good (above 4V).
Solid Red: Battery
voltage is critically low
(below 4V). Replace
transmitter batteries
TRANSMITTER CONTROLS
Battery Level Indicator
Power Switch
Power on or off the transmitter
Reverse Switch
Allows you to change the direction of
steering (ST) and throttle (TH) controls.
(The default setting for steering and
throttle is “NOR”)
Throttle Trigger
Controls power
to the motor for
forward or reverse
(See TH reverse
switch)
Stop
Reverse
(when TH reverse
switch on NOR)
Forward
(when TH reverse
switch on NOR)
Steering Wheel
Control steering. Right
and Left steering with
ST switch on NOR
(See Reverse Switch)
Steering Rate
Adjusts the amount the
front wheels move when
the steering wheel is
turned left or right
Throttle Dual Rate
Adjusts the maximum
amount of throttle the
vehicle can be given
Adjusts the neutral
point of the electronic
speed control
Throttle Trim
Adjust to make the
vehicle drive straight
with no input at the
steering wheel
Steering Trim
1. Power OFF the ESC/Receiver and transmitter.
2. Connect a fully charged battery to the ESC/Receiver.
3. Turn on the ESC/Receiver and confi rm the LED is fl ashing slowly.
4. Insert the bind plug and confi rm the LED starts to fl ash rapidly.
5. Turn on the transmitter.
6. Binding is complete when the LED turns solid.
BINDING