User Manual

ManualsBrandsECX ManualsHobby1/10 AMP MT 2WD Monster Truck Brushed BTD Kit with Unpainted Body

WARNING: Failure to exercise caution while using this product

and comply with the following warnings could result in product

malfunction, electrical issues, excessive heat, FIRE, and ultimately injury

and property damage.

• NEVER LEAVE CHARGING BATTERIES UNATTENDED.

• NEVER CHARGE BATTERIES OVERNIGHT.

• Read all safety precautions and literature prior to use of

this product.

• Never allow children under 14 years of age to charge batteries.

• Never attempt to charge dead or damaged batteries.

• Never charge a battery if the cable has been pinched or shorted.

• Never allow the batteries or charger to come into contact with

moisture at any time.

• Never charge batteries in extremely hot or cold places (recommended

between 50–80°F [10–26°C]) or place in direct sunlight.

• Always use only Ni-MH rechargeable batteries. This charger cannot

charge batteries such as “heavy duty,” “alkaline,” “mercury” or

“lithium” batteries.

• Always connect to the charger correctly.

• Always disconnect the battery and charger after charging and let them

cool between charges.

• Always inspect the battery before charging.

• Always terminate all processes and contact Horizon Hobby if the

product malfunctions.

• Always make sure you know the specifications of the battery to be

charged or discharged to ensure it meets the requirements of this

charger.

• Always constantly monitor the temperature of the battery while

charging.

• Always end the charging process if the charger or battery becomes hot

to the touch or starts to change form during the charge process.

CHARGING WARNINGS

STEP 1: CHARGING THE VEHICLE BATTERY

1. Connect the Dynamite

Speedpack

7.2V Ni-MH battery to the 200mA charger.

2. Connect the charger to an AC wall outlet.

3. Allow the battery pack to charge for 9 hours.

GETTING STARTED

1 Charge the battery

2 Assemble the AMP Monster Truck

3 Paint the AMP Monster Truck

4 Install the battery

5 Setup the transmitter

6 Drive!

WARNING: This charger is only designed to

charge NiMH batteries. Never use this charger

with a Li-Po battery.