Users Manual

____________________________________________________________________________________
SR200 IFU v1 Page 4
2. Slide the power source selector to “BAT” location.
3. The LED will be flashing during the signal repeating process.
4. If Amber LED colour is shown, the battery level is low and it requires to replace a new
battery.
5. Slide the power source selector to “USB” location if you want to turn off the Repeater.
6. Please take out the battery if you are not intended to use battery as the power source
or you will not use the Smart Repeater for a long period of time.
7. Please make sure you have turn on the Bluetooth function of your mobile device and
use the latest version of ECPIN APP.
3.2 With USB power source
1. Connect the external USB power source and the Smart Repeater SR200 with the USB
cable.
2. Slide the power source selector to “USB” location.
3. The LED will be flashing during the signal repeating process.
4. If you want to turn off the repeater, please disconnect the repeater with the USB power
source.
5. Please make sure you have turn on the Bluetooth function of your mobile device and
use the latest version of ECPIN APP.
4.0 Support
Should you have any query in using SR200, please go to visit our official website
www.ectherm.com
5.0 Regulation and Compliance
SR200 complies of different regulation and standard. For more details, please visit our
website www.ectherm.com.
5.1 FCC Regulation
FCC Compliance Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.