Datasheet

Using BIOS

Frequency/Voltage Control

Help item

F10: Save ESC: Exit+/-/: Value

Enter : Select

F9: Optimized Defaults

F1:General Help

: Move

mnlk

Manufacturer : Intel

Ratio Status: Unlocked (Min:06, Max:Unlimited)

Ratio Actual Value: 6

Ratio CMOS Setting 6

CPU Over-clocking Func. : Enabled

CPU Over-clocking Freq. : 600

PCIE Over-clocking Func. : 100

Auto Detect DIMM/PCI Clk Enabled

Spread Spectrum Enabled

CPU Voltage Normal

Memory Voltage 1.5V

* When enable the item CPU Over-clocking Func., the following picture will show.

1. The adjustment range of CPU Over-clocking Freq. depends on the

processor. And the system efficiency can be improved by adjusting the

item PCIE Over-clocking Func..

2. If the over-clocking fails, please turn off the system power. And then,

hold the PageUp key (similar to the Clear CMOS function) and turn on

the power, the BIOS will recover the safe default.

3. The improper use or the setting beyond the hardware specification will

result in the system instability.

Auto Detect DIMM/PCI Clk (Enabled)

When this item is enabled, BIOS will disable the clock signal of free DIMM/PCI slots.

Spread Spectrum (Disabled)

If you enable spread spectrum, it can significantly reduce the EMI (Electro-Magnetic

Interference) generated by the system.

Memory Current Type (7-20-7-7-8-60-4-4-4)

This ite

m shows the Memory Current Type.

DRAM Frequency (Auto)

This item shows the frequency of the DRAM in your computer.

Configure DRAM Timing by SPD (Enabled)

When this item is set to enable, the DDR timing is configured using SPD. SPD (Serial

Presence Detect) is located on the memory modules, BIOS reads information coded

in SPD during system boot up.

SPD eXtreme Memory Profile (Standard)

Use this item to select the SPD eXtreme Memory Profile. If the item is set to

Standard, the memory will work under the standard mode. If the item is set to Profile

1/2, the memory is capable to reach 1600 MHz.