Datasheet

3
Introducing the Motherboard
Integrated I/O
The motherboard has a full set of I/O ports and connectors:
Two PS/2 ports for mouse and keyboard
One serial port
One parallel port
Eight USB ports (rear panel x 4, header x 4)
One LAN port (optional)
One VGA port
Audio jacks for microphone, line-in and line-out
BIOS Firmware
The motherboard uses Award BIOS that enables users to configure many system features
including the following:
Power management
Wake-up alarms
CPU parameters
CPU and memory timing
The firmware can also be used to set parameters for different processor clock speeds.
Some hardware specifications and software items are subject to change
without prior notice.
This motherboard supports Ultra DMA bus mastering with transfer rates of 133/100/66
MB/s.
The motherboard comes with the following expansion options:
Three 32-bit PCI slots
One AGP slot
Two IDE connectors which support four IDE devices
One floppy disk drive interface
Two 7-pin SATA connectors
Expansion Options
Onboard LAN (optional)
Single Chip 100Base-TX / 10Base-T Physical Layer Solution
Dual Speed – 100 / 10 Mbps
Half and Full Duplex
MII Interface to Ethernet Controller
MII Interface to Configuration & Status
Auto Negotiation: 10 / 100, Full / Half Duplex
Meet All Applicable IEEE 802.3, 10Base-T and 100Base-Tx Standards