Specifications

Using BIOS

Power Management Setup

This page sets up some parameters for system power management operation.

Select the ACPI

state used for

System Suspend.

Help Item

Power Management Setup

ACPI Suspend Type S3

Soft-off by PWR-BTTN Instant Off

PWRON After PWR-Fail Power Off

Resume By RING Disabled

Resume By PCI/PCI-E/Lan PME Disabled

Resume By USB (S3) Disabled

Resume By PS2 KB (S3) Disabled

Resume By PS2 MS (S3) Disabled

Resume on RTC Alarm Disabled

ACPI Suspend Type (S3)

Use this item to define how your system suspends. In the default, S3, the suspend

mode is a suspend to RAM, i.e, the system shuts down with the exception of a refresh

current to the system memory.

Soft-off by PWR-BTTN (Instant off)

Under ACPI (Advanced Configuration and Power management Interface) you cancreate

a software power down. In a software power down, the system can be resumedby

Wake Up Alarms. This item lets you install a software power down that is con-trolled

by the power button on your system. If the item is set to Instant-Off, then thepower

button causes a software power down. If the item is set to Delay 4 Sec, thenyou have

to hold the power button down for four seconds to cause a software powerdown.

PWRON After PWR-Fail (Power Off)

This item enables your computer to automatically restart or return to its operating

status.

F10: Save ESC: Exit+/-/: Value

Enter : Select

F9: Default settings

F1:General Help

: Move



Legacy USB Support (Enabled)

Use this item to enable or disable support for legacy USB devices. Setting to Auto

allows the system to detect the presence of USB device at startup. If detected, the

USB controller legacy mode is enabled. If no USB device is detected, the legacy USB

support is disabled.

USB Functions (Enabled)

Use this item to enable or disable the USB function.

Parallel Port IRQ (IRQ7)

Use this item to assign IRQ to the parallel port.

Press <Esc> to return to the main menu setting page.