Setup guide

30
Using BIOS
OnBoard Floppy Controller (Enabled)
Use this item to enable or disable the onboard floppy disk drive interface.
Serial Port1 Address (3F8/IRQ4)
Use this item to enable or disable the onboard COM1 serial port, and to assign a port
address.
Parallel Port Address (378)
This item enables or disables the onboard LPT1 parallel port, and assigns a port address. The
Auto setting will detect and available address.
Parallel Port Mode (ECP)
Use this item to set the parallel port mode. You can select Normal (Standard Parallel Port),
ECP (Extended Capabilities Port), EPP (Enhanced Parallel Port), or EPP & ECP.
ECP Mode DMA Channel (DMA3)
When the onboard parallel port is set to ECP mode, the parallel port can use DMA 3 or
DMA 1.
Parallel Port IRQ (IRQ7)
Use this item to assign IRQ to the parallel port.
OnBoard PCI IDE Controller (Both)
Use this item to enable or disable the onboard PCI IDE channel.
OnBoard SATA-IDE (IDE)
Use this item to choose IDE, RAID and Disabled to enable OnBoard SATA-IDE. The
default setting is IDE.
Audio Device(Enabled)
This item enables or disables the onboard AC’97 audio chip.
OnBoard Lan Device (Enabled)
Enables and disables the onboard LAN device.
Features Setup Page
This page sets up some parameters for peripheral devices connected to the system.
CMOS SETUP UTILITY – Copyright (C) 1985-2003, American Megatrends, Inc.
Features Setup
Help Item
Allows BIOS to Enable or
Disable Floppy Controller.
OnBoard Floppy Controller
Serial Port1 Address
Parallel Port Address
Parallel Port Mode
ECP Mode DMA Channel
Parallel Port IRQ
OnBoard PCI IDE Controller
OnBoard SATA-IDE
Audio Device
Onboard LAN Device
Onboard LAN Boot Rom
OnBoard USB Function
USB Function For DOS
Enabled
3F8/IRQ4
378
ECP
DMA3
IRQ7
Both
IDE
Enabled
Enabled
Disabled
Enabled
Disabled



: Move Enter: Select +/-: Value F10: Save ESC: Exit
F1: General Help F9: Optimized Defaults