Operation Manual

41
Using BIOS
MODEM Use IRQ (Auto)
If you want an incoming call on a modem to automatically resume the system from a power-
saving mode, use this item to specify the interrupt request line (IRQ) that is used by the
modem. You might have to connect the fax/modem to the motherboard Wake On Modem
connector for this feature to work.
HDD Off After (Disabled)
The IDE hard drive will spin down if it is not accessed within a specified length of time.
Options are from 1 Min to 15 Min and Disable.
Power Button Override (Instant Off)
Under ACPI (Advanced Configuration and Power management Interface) you can create a
software power down. In a software power down, the system can be resume by Wake Up
Alarms. This item lets you install a software power down that is controlled by the power
button on your system. If the item is set to Instant-Off, then the power button causes a
software power down. If the item is set to Delay 4 Sec. then you have to hold the power
button down for four seconds to cause a software power down.
Power On After Power Fail (Off)
This item enables your computer to automatically restart or return to its last operationg
status after power returns from a power failure.
PM Wake Up Events (Press Enter)
IRQ [3-7, 9-15], NMI (Enabled)
This option determines whether any activity for IRQ 3-7/9-15 will cause the system to
wake from a power saving mode.
IRQ 8 Break Suspend (Disabled)
Determines whether the system will monitor IRQ 8 activity and wake the system from a
power saving mode when IRQ 8 is activated.
Resume By WOL/WOM/RING (Disabled)
Use this item to enable LAN or modem activity to wakeup the system from a power saving
mode.
IRQ [3-7, 9-15], NMI [Enabled]
IRQ 8 Break Suspend [Disabled]
Resume By WOL/WOM/RING [Disabled]
Resume By MACPME [Enabled]
Resume By PCI PME [Enabled]
Resume By USB (S3) [Disabled]
PS2 KB Wakeup from S3
PS2 MS Wakeup from S3
Month Alarm Na
Day of Month Alarm 0
Time (hh:mm:ss) Alarm 0 : 0 : 0
**Reload Global Timer Events**
Primary IDE [Disabled]
Secondary IDE [Disabled]
FDD, COM, LPT Port [Disabled]
PCI PIRQ[A-D]# [Disabled]

Item Help

Menu Level
Phoenix-AwardBIOS CMOS Setup Utility
PM Wake Up Events

F5:Previous Values F6:Fail-Safe Defaults F7:Optimized Defaults
: Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1: General Help