Operation Manual

Installing the Motherboard

WOM: Wake On Modem connector

If you have installed a modem, use the cable provided with the modem to plug into the

WOM connector onboard. This enables the Wake On Modem (WOM) feature. When your

system is in a power-saving mode, any modem signal automatically resumes the system. You

must enable this item using the Power Management page of the Setup Utility in the BIOS.

See Chapter 3 for more information.

Pin Signal Name Function

1 5VSB +5V stand by power

2 GND Ground

3 Ring# Wake up signal (low active)

WOL: Wake On LAN connector

If you have installed a LAN card, use the cable provided with the card to plug into the WOL

connector onboard. This enables the Wake On LAN (WOL) feature. When your system is

in a power-saving mode, any LAN signal automatically resumes the system. You must

enable this item using the Power Management page of the Setup Utility in the BIOS. See

Chapter 3 for more information.

Pin Signal Name Function

1 5VSB +5V stand by power

2 GND Ground

3 Ring# Wake up signal (low active)

IRDA: Infrared header

The motherboard supports an Infrared data port. Infrared ports allow the wireless exchange

of information between your computer and similarly equipped devices such as printers,

laptops, Personal Digital Assistants (PDAs), and other computers.

1 VCC IR power

2 KEY No pin

3 IRRX IrDA serial input

4 GND Ground

5 IRTX IrDA serial output

Pin Signal Name

Function