Owner`s manual

ECOWATER
S Y S T E M S
Typical Installation Illustrations
6
FIG. 4
Drain
Fitting
Valve
Drain
Hose
Valve
Drain
Hose
1-1/2”
Air Gap
1-1/2”
Air Gap
1-1/2””
Air Gap
1-1/2” Air Gap
LAUNDRY
TUB
SUMP
STAND
PIPE
FLOOR
DRAIN
To standpipe, sump, laundry
tub or other suitable drain.
5/8” I.D.
(minimum)
copper tube
Push in for
Bypass
Clip
Drain Fitting
CONNECTING A RIGID VALVE DRAIN TUBE
To adapt a copper tube to the filter, buy a compression fitting (garden hose thread to
5/8” I.D. minimum tube and necessary tubing from your local hardware store.
Adaptor, garden hose
thread to compression
Pull out for
filtered water
“Service”
FIG. 3FIG. 2
INSTALLATION USING 3-VALVE BYPASS
MAIN WATER PIPE
MAIN WATER PIPE
INSTALLATION USING ECOWATER BYPASS VALVE
CROSS-OVER
Use if water supply flows from the left.
Include single or 3-valve bypass.
Filtered
Water OUT
Unfiltered
Water IN
120V AC
Outlet
FILTERED
WATER
TO FILTER
INLET
UNFILTERED
WATER
FROM FILTER
OUTLET
BYPASS
Valve
OUTLET
Valve
INLET
Valve
1” Sweat
Adaptor
(not included)
O-Ring Seal (2)*
Valve
INLET
For filtered water SERVICE:
-Open the inlet and outlet
valves
For unfiltered BYPASS:
-Close the inlet and outlet
valves
-Open the bypass valve
Unfiltered Water
to Outside Faucets
* Included with filter - Pipe and
fittings supplied by installer.
1” Sweat
Adaptor
(not included)
1” NPT Inlet
Check Valve*
1” NPT Installation Adaptor*
#7214383
Bypass
Valve
Clip (2)*
O-Ring Seal (2)*
1” NPT Male Adaptor
(not included)
Valve
INLET
Clip (2)*
1” NPT Inlet
Check Valve*
1” NPT
Male Adaptor
(not included)
1” NPT Installation
Adaptor*
1”
Copper
Tube*