User guide

7.Automatically charging

？

● When robot detects the low battery, it will go back charging automatically.

● To make it easy for robot to search for charging block, you need to put the

block back to the wall and make sure there is no obstacle within 1.5 meters

ahead of the infrared receiver. Check carefully whether there is strong

reflector in front of the charger, such as ground glass, smooth ceramic vase

and so on.

● It takes time for robot to seek the charger. Robot can reserve enough

battery to go back to the charging block.

● If put the robot in a strait room, please make sure that there is enough

space for robot to go back charging.

● Robot can return to the charger if the ground situation is not too

complicated, Under extreme circumstance, such as, huge house,

complex layout would bring difficulty for robot to seek for charger. So,

you should help to put the robot back to the charging block.

● Please take care of the first automatic charging, if you find the robot keeps

turning in the certain area after trying several times to seek back, you can

help to place it on the charging block and look through the charging.

● When the robot goes back charging, the main brush will stop working.

And robot shall stay at the charger when it finishes charging and it

transfer to small currency to charge until you start operating.

8. Appointment Timing

1. After power is on, keep press for

around 3 seconds, then on LCD is light

and the number with time setting is

flashing.

2. Set hour and minute via and , press

will increase one hour or minute. While

decrease one hour and minute for .

3. When you finish setting time, press

button again and then go to the current

time setting.

Set time as

12:07 am, time

display on LCD

should be:

For example:

Set appointment time

Selection scope: hour is between 0 and 23, minute is

between 0-59.

Under normal circumstance, time display on LCD shows

current time.

Tips:

mo d e

strait room