User guide

21
5
13. Other Problems
There is much noise when the robot
works.
1. Check whether the suction of main brush is
blocked.
2. Examine and clean the main brush.
3. Examine and clean the side brush.
Turn off the power supply, and then take out of
dust box. After removing the garbage,
overturn the robot.
If the failure is still there after operating
according to the above procedure, Please
contact out after-sales service.
1. How long can robot last working under mode)
full battery?
Answer: Under normal circumstance, it is
Answer: It differs from the ground situation, around 90-120 sq, but it differs from the
It takes around 45 minutes for even floor ground situation.
such as wooden floor and ceramic tile, and
7 Why does robot stop working once it
20 minutes for short-haired carpet.
meets obstacle?
2. Is it allowed for the robot to work
Answer: Under normal circumstance,
independently without taking care of?
robot will return or seek other route when
Answer: Yes. However, you should keep it meets obstacle. However, if it
person in the room informed about robot controlled by remote control, it is not
operating to avoid tripping. able to change route in case of obstacle.
3. What kind of equipment inside the robot 8. Why there is garbage leaking from the
is used for dealing with failure? machine while robot operating?
Answer: It is equipped with photosensitive Answer: a. Please check whether there is
components which can detect the stair over too much garbage in dust box(if there is
the height of 8 centimeters; for fear that it too much dust on the floor, robot is not
would fall over. able to alarm after working for some time
even though there is too much garbage in
4 Is robot able to clean the bottom of the
dust box.). That' s why you need to clean
furniture?
dust box. b. See whether main brush is not
Answer: It is flat design, during normal
cleaned for long time, as it is tangled with
cleaning, it can go into table and bed corner
much hair and dust.
whose height is over 10 centimeters, such as
bed, wardrobe, sofa and tea table.
5 Why does robot fail to work under set
mode?
Answer: Because when there is low
battery, it will do back to charging mode
automatically.
6 What's the cleaning coverage once it is
charged full?(under automatic cleaning
.
.
9. Why does robot fail to start cleaning on
appointment time?
.
Answer: a.Confirm whether there is much
remaining battery. Appointment timing is not
applicable when robot is returning to charge
after operating cleaning. b. Check if robot is
under standby status.
.