User guide

ManualsBrandsECOVACS ManualsAir CleanerA320

NO.

Problem Solution

Does not work

1. Turn the power ON by pressing on the LCD panel. Check the Battery icon to

see amount of battery energy left in battery. If Battery icon does not light up

on the LCD panel, then the battery has no reserve energy.

2. Verify that the Charger Dock is plugged into a wall receptacle. The arm that

extends from the Charger Dock should light up with an orange cast. If the arm

is not lit, then try another receptacle. If the arm still does not light up, then the

Charger Dock should be sent to our Service Center.

3. With the Charger Dock arm lit, place the Robot in the Charger Dock so the

contacts rest against the Charger Dock contact. The LCD panel should light

up. If the Robot's LCD panel does not light up, then contact our Service

Center for further instructions.

4. Check that the switch on the bottom, underneath the Robot, has not been

turned OFF accidentally.

The machine is susceptible to various things found in the average home. Some

of these things we might not find during the initial operation or may appear

occasionally in later use.

1. Cords from lights, TV or other items can become entangled in the Drive

Wheels which will cause the Robot to stop functioning until the entanglement

is removed.

2. Papers, magazines, clothes, comfort throws, etc. can cause a lifting action

with the bottom of the Robot so that the Drive Wheels cannot function.

3. The Robot has maneuvered itself into a tight area so that no matter how it

turns, its bumper will run into an obstacle and set it in motion to turn once

again.

Each of these instances will require personal attention to attend to the Robot

and set it in an area to start working again.

The Robot does not detect a drop off and goes over the edge.

1 The Drop off could be less than 1.5 inches, or

2 The top of the Drop off (stair) could be reflective, not allowing the sensors to

work.

Reference page 20 for application of the Magnetic Strip.

The Magnetic Tape needs to be applied to the edge of the Drop Off. Be careful

to make sure a person will not trip over the magnetic tape and cause them to fall.

3. The Drop Sensors on the bottom of the unit need to be wiped free of dust.

First listen to see if the fan is running, you may also place a at the

exhaust exit to verify that the fan is working. If the fan is NOT running, call our

Service Center for further instructions.

If the fan is running, turn the power OFF on the Robot by pressing Button .

1.Remove the Top of the Robot and remove the filters.

2.Clean the filters by referencing page 22 and verify that they are not clogged.

3.Replace the filters by installing in the proper order.

4.Press the Button and observe the cleaning function.

5.If still NOT working, call our Service Center for further instructions.

piece of tissue

Machine is not

functioning

properly

Machine fails to

detect a drop off

(Stairs)

Air cleaning

function is not

working or is

greatly reduced.

12. Common Failure